TC17 Titanium Alloy Bar and Plate
TC17 Titanium Alloy Bar and Plate
Effect of Heat Treatment Process on Microstructure and Mechanical Properties of Large Size TC17 Titanium Alloy Bar & titanium sheet
effects of solution temperature, cooling method, holding time and sampling direction on the microstructure and mechanical properties of large size TC17 titanium alloy bar were studied, and the best heat treatment was selected according to the experimental results. The results show that the optimum heat treatment process of TC17 titanium alloy is
800C°/2h/WQ+630°C/8h/AC. Heat treatment in α+β phase zone and the same cooling conditions, the strength of the alloy increase and the plasticity decrease with the increasing of solution treatment followed by air cooling and aging than that after solid solution treatment followed by water cooling and aging at the same temperature. The ductility of the alloy can be improved by shortening solution holding time under the same temperature and water cooling. The large size TC17 titanium alloy bar after being forged exists anisotropism.
The effects of heat treatment on the microstructure and mechanical properties of TA17 titanium alloy sheet at room temperature were investigated. The results show that the microstructure of TA17 titanium alloy plates increases gradually by the volume fraction of α phase of equiaxed spheroids during heat treatment at different temperatures., the strength and plasticity match best in the range of 740~780°C , and at the same time the comprehensive mechanical properties of TA17 titanium alloy sheet are the best.







