TA2 Titanium Alloy National Standard Heat Treatment Process Specification And Analysis Of Technical Points
TA2 titanium alloy has a wide range of applications in aerospace, energy equipment and other key fields as an important material in the industrial field because of its special characteristics in the industrial field. Below we will systematically analyze its heat treatment process specification and implementation requirements based on the national standard system.
First, Specifications during heat treatment
1. Annealing process parameters
(1)Temperature range: According to GB/T3620.1-2016, the temperature of TA2 annealing should be controlled above 750-800℃.
(2)Holding time: 0.5-1 hour for partial thickness ≤25mm, 1.5-2 hours>25 mm.
(3)Cooling method: air cooling or cooling furnace (≤300℃/h)
2. Stress relief annealing
(1) Temperature range: 480-595°C
(2) Holding time: according to the thickness of the workpiece every 25mm to keep 1 hour calculation
(3) Cooling method: air cooling to room temperature

Second, the implementation of the standard system
1.GB/T 3620.1-2016 Titanium and titanium alloy grades and chemical compositions
2.GB/T 5193-2018 Mechanical properties of titanium and titanium alloy processed products
3.GB/T 23605-2020 titanium alloy β-transition temperature determination method
Third, the main points of process control
1. Temperature accuracy control: ±15℃ (conventional parts), ±10℃ (aviation parts)
2. Atmosphere requirements in the furnace: argon protection (purity≥99.995%)
3. Furnace installation method: avoid stacking and maintain uniform heating
Fourth, common process misunderstandings
1. Excessive pursuit of high-temperature annealing: may lead to grain roughening and reduce fatigue strength
2. Improper cooling rate control: rapid cooling is prone to residual stress
3. Neglect of surface pollution: failure to clean thoroughly before heat treatment can easily lead to hydrogen seepage

V. Analysis of Technical disputes
1. Reference for calculation of insulation time: the difference in applicability calculated by thickness and quality method
2. Cooling rate control: the different requirements of aviation parts and conventional industrial parts
3. Choice of heat treatment equipment: cost-effective balance between vacuum furnace and protective atmosphere furnace
Six, quality control requirements
1. Batch sampling and testing: 5% samples are taken for each batch of heat treatment
2. Verification of mechanical properties: Focus on testing tensile strength (≥440MPa) and elongation (≥20%)
3. Microstructure detection: The content of alpha phase should be controlled at more than 95%
The heat treatment of TA2 titanium alloy should strictly follow the requirements of national standards and optimize the process parameters based on specific application scenarios. It is recommended that production enterprises establish a sound process monitoring system to ensure product quality stability through metallographic analysis, mechanical testing and other means. At the same time, it is necessary to pay attention to the update of domestic and foreign standards and adjust the production process in a timely manner.







